Read the instructions to find out how much to spray on the bumper sticker, and feel free to use the spray several times if needed. Let the adhesive remover sit for roughly five minutes.
Peel away the sticker using a plastic putty knife or your fingers. After the adhesive remover works its way into the sticker, start removing the sticker by lifting up a corner and pulling it off slowly.
Spray specific stuck spots to help loosen them up. Wipe away any extra residue using rubbing alcohol. Dampen a microfiber towel or old cloth with rubbing alcohol and gently wipe off any sticky spots left from your sticker removal.
The alcohol should take away any residue that's left, leaving you with a clean surface. Did you know you can get premium answers for this article?
Unlock premium answers by supporting wikiHow. Chad Zani Auto Detailing Expert. Chad Zani. Support wikiHow by unlocking this expert answer. Not Helpful 0 Helpful 1. Not Helpful 0 Helpful 0. Not Helpful 1 Helpful 0. The problem is that the bumper sticker is dried on and has no adhesive, so I can't peel it. Any ideas? Go to the auto parts store and buy a decal remover.
It's a rubber disk mounted on a shaft that you place in a drill; while spinning the drill motor, use the rubber disk to remove the sticker without damaging the vehicle finish. Not Helpful 4 Helpful 3. Include your email address to get a message when this question is answered. By using this service, some information may be shared with YouTube. Only use razor blades on glass surfaces—they can cause damage to paint or metal.
Helpful 1 Not Helpful 0. Avoid holding a heat source on your bumper sticker for too long, or too closely, as this can cause the paint to melt. Helpful 0 Not Helpful 1. Related wikiHows How to. How to. That handy can of WD or a similar low-cost lubricant is great on unwanted bumper stickers. After donning safety glasses, spray the superhero solution over all four edges of the bumper sticker and allow five minutes of dwell time.
Then, using your fingers, a credit card, or a rubber spatula, lift up a corner and gradually peel off the bumper sticker, keeping it as flat as possible to minimize residue. If areas stick during the process, spray a small amount of WD to the stubborn portion to loosen it up. What little residue remains once the bumper sticker is removed can be wiped away with a soft cloth dampened with rubbing alcohol.
Apply a fresh coat of wax to the bumper with a car-safe buffer pad such as Chemical Guys Buffing Pads to restore shine. Set a blow dryer to the low heat setting and aim the nozzle six inches from the bumper sticker. While they can be a fun addition to some vehicle exteriors when it comes time to sell or trade in you are better off without them. So, how can you remove old bumper stickers without causing any damage to your vehicle?
We have three tips for easier removal below. The trick to clean bumper sticker removal is to find a process that removes not only the top layer of the sticker but also the adhesive underneath. Most sticker adhesives will start to melt when they come in to contact with direct heat. Get a cloth or a sponge and some soapy water, and wash the decal and the surrounding area. Or, you can plan to remove the decal after you run through a car wash.
The next step is to heat up the car sticker or decal to weaken and loosen the adhesive. The best tool for the job is a hair blow dryer, as a heat gun is too powerful and could damage your paint job. Find a heavy-duty extension cord if you need to, and set the hair blow dryer to its highest heat setting.
Distribute the heat evenly throughout the sticker and be sure to heat the edges of it. Give it a good two minutes of heating before you stop. Your next best bet is to pour boiling water over the decal to heat the adhesive, but this is a little messy and hot , and you may need to do it several times to get the job done.
0コメント